Dimensions of the Model 150 included a length of 87.8 feet, a wingspan of 79 feet and a height of 11 feet. Empty weight was 57,550lb to a gross weight of 103,635lb. Power from each Lyulka TR-3A series engine registered 11,025lb.
Internally, the bomber was cleared to carry up to 13,230lb of conventional drop ordnance. For local defense it was outfitted with cannons: 1 x 23mm Sh-23 gun was mounted in a fixed, forward-firing position along the starboard side of the forward fuselage. 2 x 23mm Sh-23 guns were held in DB-23 remote-controlled dorsal barbettes (the gunner facing aft in the primary cockpit) and 2 x 23mm Sh-23 guns were mounted in a similar DB-25 remote-controlled barbette at the tail (manned by a dedicated gunner seated in the tail unit).
With construction complete, the Model 150 prototype went airborne for the first time on September 5th, 1952. Performance specs went on to include a maximum speed of 605 miles-per-hour, a range out to 2,800 miles and a service ceiling of 41,000 feet (crew sections were pressurized for this). Rate-of-climb reached 3,280 feet-per-minute and the bomber held a mission endurance window of over 5 hours and 30 minutes.
A static test article was also completed while there were also plans to develop a tactical photo-reconnaissance mark as the "Model 150-R". Design work was seen for this version in 1951 and a mockup completed but little else. The "Model 152" was another related offshoot of Baade's work and intended for passenger airliner service (its design followed the lines of Baade's Model 150 bomber). Two flying prototypes of this form were completed under the East German banner following Baade's return to German soil but the type never entered formal service.
The Model 150 prototype continued in flight trials for 1952 but development was slow due to typical technological hurdles and low support from Soviet authorities. The aircraft managed a total of seventeen flights for its time in the air with the final one taking place in May of 1953 - a crash landing caused enough damage to ensure the Model 150 would be grounded for a length of time at which point all interest in the program evaporated and the prototype was not repaired. The German engineers were then allowed to return to East Germany to continue their lives.
Content ©MilitaryFactory.com; No Reproduction Permitted.